![]() Connect WHITE wire from receiver to WHITE wire from ceiling. Connect BLACK wire from receiver to BLACK wire from ceiling. Insert the receiver from the remote pack (M) into the mounting bracket (A) with the flat side towards the ceiling. Using a dimmer switch or variable speed wall control will damage the fan.ħ. IMPORTANT: Do NOT use this fan with a dimmer switch or variable speed wall control.If not fully engaged, the fan could fall, which could result in serious injury or death. DANGER: Be careful when aligning tab to slot.Rotate fan until slot on hanger ball engages the tab on mounting bracket (A) Install hanger ball on top of downrod (E) into mounting bracket (A) opening. Insert previously removed pin through holes on yoke and downrod (E), then insert previously removed clip into pin until it snaps into place. Slip downrod (E) into housing yoke, aligning holes on both parts. Loosen preassembled set screws from yoke on fan motor assembly (H). NOTE: The remainder of the instructions will reference downrod assembly (E), but note all of the instructions are applicable even if an accessory downrod was used.ĥ.NOTE: The male plug of the lead wire (N) should extend out of the other end of the downrod.Then, thread lead wire (N) through the downrod and connect the MALE plug from the top of motor assembly (H) to the FEMALE plug from the lead wire (N). If you are installing the fan with a longer downrod (sold separately), insert it through the canopy (B), canopy cover (C) and yoke cover (D).Thread wires from fan motor assembly through downrod (E) Save for later use.Ĥa.STANDARD DOWNROD INSTALLATION: Insert downrod (E) through canopy (B), canopy cover (C), and yoke cover (D). Remove preassembled pin and clip from downrod (E). IMPORTANT: If angle mounting, make sure open end of mounting bracket (A) is installed facing the higher part of the ceiling.ģ. Install mounting bracket (A) to outlet box (not included) by sliding mounting bracket (A) over the two outlet box screws (not included). Downrod Mount (standard or angled ceiling) IMPORTANT: lf angle mounting, check to make sure the ceiling angle is not steeper than 20°Ģ. If the blades are not installed, the motor will not function properlyġ. IMPORTANT NOTE: The blades must be installed before attempting to operate the fan.TTools Required for Assembly (not included): Phillips screwdriver, step ladder, electrical tape, pliers, wire cutters, wire strippers. ![]() If any part is missing or damaged, do not attempt to assemble the product. Compare all parts with the package contents list and hardware contents list. Before beginning the assembly of this product, ensure that all parts are present.Harbor Breeze 00581 Saratoga 60-in Oil-Rubbed Bronze LED Indoor Residential Ceiling Fan - Use Manual - Use Guide PDF.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |